Analyze the reasons for the high water temperature of the wood grabber
Time:
Nov 12,2021
The high water temperature of the wood grabber is a common problem encountered by the wood grabber. What is the reason for this common failure situation? The following is an analysis of the reasons for the high water temperature of the wood grabber from several aspects
The high water temperature of the wood grabber is a common problem encountered by the wood grabber. What is the reason for this common failure situation? The following is an analysis of the reasons for the high water temperature of the wood grabber from several aspects.：
1. The amount of engine oil in the car will also affect the water temperature, so it is necessary to maintain a basic range.
2. The wooden grabber has been working in harsh environments for a long time.It is inevitable that a large amount of debris and dust will fall around the engine.Therefore, frequent inspection and removal of debris near the equipment is conducive to reducing the water temperature of the engine.
3. Whether the fan is working normally, it is also necessary to check whether the transmission belt of the transmission system is loose.The transmission belt of the transmission system is too loose or too tight, which will cause the water temperature to rise.
4. The water flow is small or there are traces of leakage in the water storage tank.It is carried out in daily maintenance work.If the water temperature is too high, please check whether the water circulation system is normal.The inspection method is to touch the inlet pipe of the heat pipe radiator with your hand.The temperature interval of the sewer pipe should not be too far apart.If the temperature difference is large, please check whether the centrifugal pump is not working properly or the water temperature sensor cannot be turned on.
5. The front part of the cooling tower is clogged with debris, which blocks the flow of heat pipe cooling gas.Excessive oil pollution on the surface of the engine can also damage the heat pipe to dissipate heat.
6. The engine of the wood grabber is under heavy load, the ignition is too late, and the output power of the hydraulic master pump is too high, which can also cause the water temperature to be too high.
7. If it is a fully computer-controlled machine, there is too much or too little oil in the gasoline pump, or the angle of the oil pump is wrong, which can easily cause the water temperature to be too high.
8. Apply antifreeze appropriately. If your machine evaporates after adding antifreeze, it means that you have not added ethylene glycol antifreeze, because the melting point of ethylene glycol antifreeze can reach 105-110 degrees, which is higher than the boiling point of water. It is not easy to evaporate easily.
9. Damage to the lid of the water tank of the wood grabber will also cause the water temperature to rise.Because the lid of the water tank is broken, it will easily cause water to enter in the case of the water circulation system.Therefore, the water temperature will be higher.
E-mail：